Agua1 2 Posted March 23, 2019 If your Bobcat has a foot throttle;e and it becomes unresponsive here is how you can re set it. I am told that low voltage can cause this. On ours a weak battery seemed to be what kept setting the fault. The unit always started with the weak battery, but when voltage dropped, the peddle went dead Fault code M2899 = Throttle secondary sensor not calibrated Procedure 1. Key on, do not start 2. Hold the auto idle button down until the display changes (cannot remember what it says) 3. Cycle the foot throttle several times (I believe the display changes again) 4. Key off Share this post Link to post Share on other sites